The present article provides an improvement in the method to correct indirect strain measurements in triaxial compressive strength tests through axial displacement and hydraulic fluid volume change measurements. The improvement focused on reducing the parameters of the formula proposed for indirect volumetric strain in the original method, thereby facilitating the development of a simpler formula in which the radial strain depends on only two parameters: the initial volume of the rock specimen and the volume changes of the hydraulic fluid for each instant. The comparison between the improvement proposed, and original method resulted in a mean absolute difference of 0.003. center dot This improvement does not depend on the axial strain, unlike the original method, which requires correcting the indirect axial strain measurements before correcting the indirect radial strain measurements. center dot This improvement can be useful for research on the stress-strain behavior of intact rock under laboratory conditions, such as in the study of the post-peak state.