Muestra métricas de impacto externas asociadas a la publicación. Para mayor detalle:
Departamento Gestión de Conocimiento, Monitoreo y Prospección
Consultas o comentarios: productividad@anid.cl
Consultas o comentarios: productividad@anid.cl
3D Printed Anisotropic Dielectric Polarizer for 38 GHz Low Profile Horn Antenna Array
| Indexado |
|
||||
| DOI | 10.1109/ISAP53582.2022.9998625 | ||||
| Año | 2022 | ||||
| Tipo | proceedings paper |
Citas Totales
Autores Afiliación Chile
Instituciones Chile
% Participación
Internacional
Autores
Afiliación Extranjera
Instituciones
Extranjeras
Abstract
The following article presents the design of a 3D- printed anisotropic material used as a circular polarizer for a low- profile horn antenna array at 38 GHz. The proposed design is manufactured and measured. Measurement results shoiv that the use of loiv-loss filaments is suitable for this type of designs at mm-wave frequencies, being a cost-effective solution.
Revista
| Revista | ISSN |
|---|---|
| 2018 Ieee Antennas And Propagation Society International Symposium On Antennas And Propagation & Usnc/Ursi National Radio Science Meeting | 1522-3965 |
| Ord. | Autor | Género | Institución - País |
|---|---|---|---|
| 1 | Castro, Nelson | Hombre |
Universidad Carlos III de Madrid - España
Univ Carlos III Madrid - España |
| 2 | Pizarro, Francisco | Hombre |
Pontificia Universidad Católica de Valparaíso - Chile
|
| 3 | Rajo-Iglesias, Eva | - |
Universidad Carlos III de Madrid - España
Univ Carlos III Madrid - España |
| 4 | IEEE | Corporación |
| Agradecimiento |
|---|
| This article was partially funded by FONDECYT REGULAR 1221090 and by project PID2019-107688RB-C21 funded by MCIN/AEI/10.13039/501100011033. |
| This article was partially funded by FONDECYT REGULAR 1221090 and by project PID2019-107688RB-C21 funded by MCIN/AEI/10.13039/501100011033. |
